Car Frame Machine Operating Procedures

Car Frame Machine Operating Procedures

First, enter the work area to wear a good work clothes, gloves; not allowed to wear slippers, high heels into; Second, pre-operation inspection. 1. Before the equipment is operated, the site should be cleaned. The platform and its surroundings can not stack debris, clean the oil and gas pipelines, and prevent the pipeline from being squeezed during operation. 2. Check whether the connectors of the oil and gas pipeline are connected and the pipeline is damaged. The damage should be promptly replaced, and it is forbidden to use it again. 3. Check whether the tower column fixing bolt is loose and whether the height adjustment bolt is loose. It must be tightened in time to avoid the damage of personnel articles. Third, the operation rules of the upper and lower vehicles. 1. When the platform is lifted and lowered, equipment accessories are forbidden to stand on people. When the vehicle is on the upper and lower sides, someone must be on the side for guidance. The vehicle should be parked at the designated position on the platform. 2. The platform should be operated smoothly to check whether the hydraulic pump has oil leakage or lack of oil; When taking off and landing platforms, separate the traction tower to check whether the lifting lock spring is normally returned; 4. The vehicle should tighten the parking brake on the platform, and the tire should be fixed properly before and after. 5, the platform activity leg lock pin must be locked after the platform rises; Fourth, the vehicle fixed operating procedures. 1. Check the jaws before the clamps are clamped. There should be no oil stains or debris. 2. Check whether there are deformations and cracks in the various parts of the clamp. If necessary, replace the clamps to prevent them from flying after the force is broken. 3. The main clamp fixing bolts The jaw fastening bolts must be fully tightened; V. Measuring procedures. 1. The measuring tool should be handled with care, not to collide, to prevent the measuring tool from being deformed or damaged. 2. When measuring the reading, the glasses and the reading position should be parallel to reduce the reading error. 3. After the measurement is completed, the measuring tool should be immediately put back into the original position of the tool truck. 4、The measuring tool is fixed. Retighten the connecting screw and tighten it again. Do not use too much force. 1, before the stretching operation, check the chain, sheet metal tools, pull ring is complete, no damage, cracks, scratches can be used; 2, when tightening the tower column fastening bolts to tighten; 3, check the chain locking mechanism The chain can not be twisted, all the links in a straight line; 4, pay attention to the stretching force when stretching does not exceed the rated load of the tool; 5, do not hit the sheet metal tools and chains when stretching; 6, stretching, related personnel Do not force the chain in the same direction as the chain; 7. When the tensile force is relatively large, the vehicle should be fixed to the platform with the chain on the opposite side of the pulling direction. 8. When the tool is stretched, the sheet metal tool and the chain The insurance rope or protection device should be added between them to avoid causing the sheet metal tools to fall off; 7. After the equipment is used, clean the site, sheet metal tools, measuring tools, fixtures and other items, and wipe cleanly and orderly on the tool truck. VIII. Parts damage The hydraulic system is faulty and it is forbidden to open and repair by itself, so as to avoid damage or loss of parts, resulting in irreparable; it is forbidden to adjust the oil pump relief valve.