Standard for operation flow and management methods of lacquer room

We talk about how the paint room is safe to operate and manage standards, we divide it roughly into two categories:

First, spray paint program:

1, turn on the total switch, and open the indoor lighting.

2, the car paint ready to start the paint button.

3, press spray temperature key.

4. Check the temperature of the paint room and adjust the temperature at any time according to the weather change.

5, temperature below 20 degrees, can be based on their own level of use of baking room temperature key to adjust temperature, and open the fuel switch.

6, the temperature is higher than the average temperature of the paint, painter should adjust the paint ratio and achieve the best results according to the need.

7, paint finish, clean the paint room is not needed, turn off the lights, do not need to paint when the total switch off.

Second, the baking process:

1, after the painting finishes, press the stop button to turn off the lighting.

2, push the paint to run the switch, and then push off the timer switch.

3, press the Lacquer key, adjust the temperature required for baking paint.

4, rotate the time button, adjust to the time required. A t stands for 20 minutes.

5, a few seconds later, the paint room will automatically start, after burning painter to leave again.

6, the paint room running switches, timing switches, paint button back to the state of painting, the launch of the car, shut down the total switch.