The operation process and management method of the paint room

The operation process and management method of the paint room

   Regarding the safe operation and management standards of the car paint booth, we roughly divide it into two categories:

1. Painting procedure:

1. Turn on the main switch and turn on the indoor lighting.

2. The car is ready for painting, start the painting button.

3. Press the spray paint temperature key.

4. Check the temperature of the paint baking room and adjust the temperature required by the painting process according to the weather changes at any time.

5. When the temperature is about 1000 degrees lower, you can use the paint room temperature key to adjust the temperature according to your level and turn on the fuel switch.

, When the temperature is higher than the average paint temperature, the painter should adjust the paint ratio and achieve the best effect according to the needs.

, After painting, remove unnecessary objects in the paint booth, turn off the light, and turn off the main switch when paint is not needed.

Two, paint procedure:

1. After painting, press the stop button to turn off the lighting.

2. Turn on the paint operation switch, and then turn on the timing switch.

3. Press the paint button to adjust the temperature required for the paint.

4. Rotate the time button to adjust to the required time.

5. After a few seconds, the Weilongda paint booth will automatically start, and the painter will leave after burning.

6. Set the operation switch, timer switch and paint button of the paint baking room back to the painting state, push out the car, and turn off the main switch.